Classic Blind Installation Guide

INSTALLING THE CLASSIC BLIND

STEP 1. Check the package contents

• Classic blind 1 pc
• Wall brackets 2 pcs (depending on the version, with or without end caps)
• Chain stopper 2 pcs
• Screws 4 pcs (universal, for wall)
• Wall plugs 4 pcs (universal, for wall)

STEP 2. Check the blind dimensions by placing the blind in front of the window, either on the wall or between the window recesses (depending on your order). When mounted on the wall, the fabric should be 5–8 cm wider than the opening on each side.

STEP 3. Installing the brackets

• When mounting to the wall, place the wall brackets at both ends of the blind.
• Measure the total width of the blind (blind + brackets).
• Measure the width of the window opening where the blind will be installed. Subtract the window opening width from the total blind width. Divide the result by two. This is the distance the backs of the brackets must be from the window recess.
• Measure the bracket height approximately 8 cm above the top edge of the window recess.
• When mounting between the window recesses, the total width including brackets should be 5–10 mm narrower than the opening width.

STEP 4. Mark the screw hole positions on the wall using the wall brackets. Then use a drill or hammer drill to drill holes for the wall plugs. Insert the wall plugs and install the wall brackets.

STEP 5. Install the blind between the wall brackets. Add the chain stoppers. To do this, unroll the blind and place the included plastic washer (stopper) between the chain beads so that the blind cannot roll down past the windowsill.

For more information: www.rulo.ee / info@rulo.ee